Juniper Networks M10i manual Configuring the Internal Compact Flash Disk

M10i Internet Router Hardware Guide

Figure 50: Inserting the Internal Flash Drive

Configuring the Internal Compact Flash Disk

After installing the internal compact flash disk for the first time, you must copy the software from the Routing Engine's hard disk to the internal compact flash disk.

To copy software to the compact flash disk, perform the following procedure:

1.Install the internal compact flash disk and replace the Routing Engine as described in “Inserting the Internal Compact Flash Disk” on page 127 and “Installing a Routing Engine” on page 123.

2.On the console or other management device connected to the Routing Engine, enter CLI operational mode and issue the following command to copy the currently running and active file system partitions on the router to standby partitions on the internal compact flash disk.

user@host> request system snapshot partition

Wait until a message appears on the console confirming that the procedure is complete.

For more information about the command, see the JUNOS System Basics and

Services Command Reference.

3.Issue the following command to reboot the router's software:

user@host> request system reboot

128■ Replacing Routing Engine Components