Juniper Networks M10i manual Powering On the Router

Chapter 9: Connecting the Router

Powering On the Router

To power on the router, follow this procedure:

1.Verify that the power supplies are fully inserted in the chassis and the thumbscrews on their faceplates are tightened.

2.For each power supply on an AC-powered router, verify that the ends of the power cord are firmly plugged into the appliance inlet on the power supply faceplate and the external power source receptacle.

For each power supply on a DC-powered router, verify that the source DC power cables are connected to the appropriate terminal on the power supply faceplate: the positive (+) source cable to the return terminal (labeled RTN) and the negative (–) source cable to the input terminal (labeled –48V).

3.Verify that an external management device is connected to one of the Routing Engine ports on the Routing Engine (AUX/MODEM, CONSOLE, or MGMT). For more information on connecting management devices, see “Connecting the Router to Management Devices” on page 59.

4.Turn on the power to the external management device.

5.Press the power switch for the power supplies in slots P/S 0 and P/S 1 to the ON ( ) position. On both AC and DC power supplies, the switch is located on the power supply faceplate.

6.Verify that the OUTPUT OK LED on each power supply faceplate eventually lights steadily.

NOTE: After powering off a power supply, wait at least 60 seconds before turning it back on. After powering on a power supply, wait at least 60 seconds before turning it off.

If the router is completely powered off when you power on the power supply, the Routing Engine boots as the power supply completes its startup sequence. If the Routing Engine finishes booting and you need to power off the router again, first issue the CLI request system halt command. For more information, see “Disconnecting AC Power from the Router” on page 111 or “Disconnecting DC Power from the Router” on page 117.

After a power supply is powered on, it can take up to 60 seconds for status indicators—such as LEDs on the power supply and show chassis commands—to indicate that the power supply is functioning normally. Ignore error indicators that appear during the first 60 seconds.

7.Press the power switch for any additional power supplies to the ON ( ) position and verify that the OUTPUT OK LED on each power supply faceplate lights steadily. If the LED does not light after 60 seconds, verify that the power supply is properly inserted into the chassis and repeat the cable installation procedures described

Providing Power to the Router ■ 65