Juniper Networks M10i manual Routing Protocol Process, IPv4 Routing Protocols

M10i Internet Router Hardware Guide

■Routing Protocol Process on page 26

■VPNs on page 30

■Interface Process on page 31

■Chassis Process on page 31

■SNMP and MIB II Processes on page 31

■Management Process on page 31

■Routing Engine Kernel on page 31

Routing Protocol Process

The JUNOS software routing protocol process controls the routing protocols that run on the router. The routing protocol process starts all configured routing protocols and handles all routing messages. It consolidates the routing information learned from all routing protocols into common routing tables. From this routing information, the routing protocol process determines the active routes to network destinations and installs these routes into the Routing Engine's forwarding table. Finally, the routing protocol process implements the routing policies you specify, which determine how routing information is transferred between the routing protocols and the routing table.

This section discusses the following topics:

■IPv4 Routing Protocols on page 26

■IPv6 Routing Protocols on page 28

■Routing and Forwarding Tables on page 29

■Routing Policy on page 29

For complete information about routing concepts, see the JUNOS Internet software configuration guides.

IPv4 Routing Protocols

The JUNOS Internet software implements full IP routing functionality, providing support for IP version 4 (IPv4). The routing protocols are fully interoperable with existing IP routing protocols and provide the scale and control necessary for the Internet core. The software provides support for the following routing and traffic engineering protocols:

■Unicast routing protocols

26■ Routing Engine Software Components