Juniper Networks M10i manual Services Command Reference

M10i Internet Router Hardware Guide

NOTE: Wait until a message appears on the console confirming that the operating system has halted.

For more information about the command, see the JUNOS System Basics and

Services Command Reference.

NOTE: The router might continue forwarding traffic for a few minutes after the request system halt command has been issued.

5.Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and connect the strap to one of the ESD points on the chassis. Make sure the router is attached to a proper earth ground. For more information about ESD, see “Preventing Electrostatic Discharge Damage” on page 140.

6.Loosen the thumbscrews located at each end of the Routing Engine faceplate, using a Phillips screwdriver if necessary.

7.Grasp the handle and slide the unit about halfway out of the chassis.

CAUTION: Slide the Routing Engine straight out of the chassis. Damage can result if it gets lodged because of uneven movement.

8.Place one hand under the Routing Engine to support it, slide it completely out of the chassis, and place it on the antistatic mat or in the electrostatic bag.

9.Grasp the handle of the HCM and slide the unit about halfway out of the chassis.

CAUTION: Slide the HCM straight out of the chassis. Damage can result if it gets lodged because of uneven movement.

10.Place one hand under the HCM to support it, slide it completely out of the chassis, and place it on the antistatic mat or in the electrostatic bag.

94■ Replacing an HCM