Juniper Networks M10i manual Cable Connector Pinouts, RJ-45 Connector Pinout

Appendix F

Cable Connector Pinouts

This chapter describes the pinouts for the following cable connectors:

■RJ-45 Connector Pinouts for the Routing Engine MGMT Port on page 199

■DB-9 Connector Pinouts for the Routing Engine AUX/MODEM and CONSOLE Ports on page 200

■RJ-48 Cable Pinouts for E1 and T1 PICs on page 200

■X.21 and V.35 Cable Pinouts for EIA-530 PIC on page 203

■RJ-21 Cable Pinouts for Fast Ethernet 12-Port PIC on page 205

RJ-45 Connector Pinouts for the Routing Engine MGMT Port

The port on the Routing Engine labeled MGMT is an autosensing 10/100-Mbps Ethernet RJ-45 receptacle that accepts an Ethernet cable for connecting the Routing Engine to a management LAN (or other device that supports out-of-band management). For more information, see “Routing Engine Interface Ports” on page 16. Table 25 on page 199 describes the RJ-45 connector pinout.

Table 25: RJ-45 Connector Pinout

Pin	Signal
1	TX+
2	TX-
3	RX+
4	Termination network
5	Termination network
6	RX-
7	Termination network
8	Termination network

RJ-45 Connector Pinouts for the Routing Engine MGMT Port ■ 199