Kodak 1200I manual Load Windows Driver

KODAK 1200i WIDE-FORMAT PRINTING SYSTEM

5). Load Windows Driver

a)Load the Kodak 1200i System CD into CD-ROM drive (CD should launch automatically). Select Software Installation, then Printer Setup.

b)A Windows driver will be loaded (just follow the default button selections). If configuration is successful the printer will be automatically detected across the new network (Note: the

picture at right is an example only; printer name and IP address should be displayed correctly). If the printer is not located perform steps 1-5 again. NOTE: Ensure Subnet mask and Default Gateway addresses are assigned and are the same at both the printer and the workstation.

c)NOTE: If steps a. and b. above are unsuccessful then install a standard TCP/IP printer port driver and configure or assign an IP address to an existing NJ1000i/Kodak 1200i printer driver (or TCP/IP port) to match the printers IP address. If necessary add a Standard TCP/IP driver (load Generic text only driver) if not already installed. Open up Printers (START – SETTINGS

– PRINTERS). Select an existing TCP/IP port and choose ‘Configure Port’ if making a modification; please note the port name will stay the same.

Technical Training Guide 20