KODAK 1200i WIDE-FORMAT PRINTING SYSTEM
Preventive Maintenance
Periodic Maintenance is required at the following intervals; this type of service should only be performed by authorized service providers.
1.Replace carriage bushings every 1000 plot hours or when vertical banding or ‘Internal Error - Carriage Axis’ errors are observed (bushings will typically last between 630 and 2200 plot hours depending on the print environment conditions, cleanliness, routine maintenance practices and type of actual printing performed).
NOTE: it is possible for bushings to become dirty prior to 500 plot hours causing horizontal banding and/or shuddering of the carriage assembly during movement. Remove bushings from carriage (3 screws at each side) and clean lint/debris from bushings with dry
-Inspect and verify bushing shims (2 per bushing) are present or vertical banding may result due to carriage chatter.
2.Replace the service station every 2000 plot hours (station wipers may require frequent replacement depending on customer maintenance).
3.Replace the idler, frame
tensioner, spring and carriage belt every 2000 plot hours.
4.Replace the servo motor every 4000 plot hours.
Technical Training Guide | 39 |
