Kodak 1200I manual <color> Pen Error – Invalid OEM ID, color Pen Error - Ink Warranty Mismatch

KODAK 1200i WIDE-FORMAT PRINTING SYSTEM

system wide acceptable range is between 450 and 540 (go to Cartridge Status – press outside keys to view individual cartridge status/information, refer to bottom of page 8).

[<color>] Pen Error – Invalid OEM ID!

Translation: The pen OEM ID does not match the main-board OEM ID. For ENCAD cartridge all OEM values should be 1. Replace cartridge under warranty if one cartridge is different than the rest.

[<color>] Pen Error – Ink Warranty Mismatch!

Translation: The system was unable to update pen warranty status (ID-chip).

[<color>] Pen Error – Invalid Chip ID!

Translation: The pen ID chip serial number is invalid. Reseat or replace cartridge under warranty.

For the above error messages replace the cartridge with a qualified replacement. If cartridge replacement does not solve the issue then check flex driver cable and trailing cable connectivity. Replace appropriate flex driver cable. Replace trailing cable. Replace carriage board (defective jack connector).

If the Pen Error is related to an ID-chip communication failure, the error message format changes to the following:

[<color>] Pen Error – Code < # > (# ranges from 2 to 7)

Where:

2 = “<color> Pen Error - Pri CRC Failed!”

3 = “<color> Pen Error - Sec CRC Failed!”

4 = “<color> Pen Error - No Response!”

5 = “<color> Pen Error - Write Protected!”

6 = “<color> Pen Error - Copy Failed!”

7 = “<color> Pen Error - MAC Mismatch!” Translation: The ID-chip or its connection is faulty.

These communication error messages are displayed in the “Cart Info” secondary menu. This display menu is made visible by pressing the associated cartridge color button (F1-F6).

604 K: BLACK QiD TSR: XXX

MFGl X-X-XXX OEM: 1 ID: 6

XXXXXXXXXXXXX

TSR FOUND +

NOTE: the TSR range is normally between 450 and 540; cartridges operate the ‘best’ between TSR levels between 480 and 510 however.

Technical Training Guide 48