KODAK 1200i WIDE-FORMAT PRINTING SYSTEM
6). At Command Prompt, ping the printer to verify connectivity between computer and the printer. At computer select START – PROGRAMS – ACCESSORIES – COMMAND PROMPT (or similar). Type: ping 192.168.24.74 (as an example) and select ENTER. Four (4) ‘REPLY …..’ messages should appear. If
‘REQUESTED TIME OUT….’ messages appear then connectivity is incorrect –
verify steps 1 through 6 again.
7). Assign IP address at RIP (host workstation) and set data type. The IP address will be the same as the printer’s IP address (i.e. 192.168.24.74). Data type must be set to <9100> for proper data transfer to occur. Pictured below is ONYX’s printer port setup splash screen; a port test may be activated once values are set – a ‘Valid IP Address!’ message should appear. RIP and print operations may begin at this point.
Technical Training Guide | 21 |
