Kodak 1200I manual Technical Training Guide

KODAK 1200i WIDE-FORMAT PRINTING SYSTEM

4.Platen Surface & Cutter Groove (lint-free swab/lint-free towel dampened with Windex or a mild dish soap & water solution). Remove media from printer and wipe down platen and cutter groove until ink residues are no longer visible on cleaning swab/towel. Using a toothpick or paperclip, gently remove paper fibers or similar debris from the cutter groove.

5.Carriage Belt (lint-free towel dampened with Windex or a mild dish soap & water solution). Thoroughly clean the entire length of the inside surface of carriage belt).

6.Flex Driver Cables (lint-free towel or lint-free swab dampened with Windex solution or isopropyl alcohol). Remove all print heads from carriage assembly. Thoroughly clean all 6 (six) carriage flex driver cables; ensure no lint fibers or ink residues remain on cable surfaces.

NOTE: Routine cleaning of the flex driver cables is very important when the printer is running in certain print

modes [print pass modes 2, 3, 4 and GB Mode available in firmware >2.1.0].

NOTE 2: If ink residue is observed on cable surfaces at any time printing should be immediately suspended and a flex cable and rear cartridge cleaning maintenance actions should be performed. Also refer to section B below.

CAUTION: Print heads may become damaged if media is allowed to scrape against the lower jet plate surface during printing or through direct contact with ink residues on service station seals when the carriage is at the home position.

Technical Training Guide 34