Cleaning the calibration area

1.Open the scanner cover.

2.Remove dust and debris from this area by using a Staticide wipe or a small brush. Be careful not to scratch the glass (may cause image quality problems) or bend the white tabs on the front calibration guide (bending the tabs may cause paper feeding problems) when cleaning the calibration area.

IMPORTANT: Staticide wipes contain isopropanol which can cause eye irritation and dry skin. Wash your hands with soap and water after performing maintenance procedures. Refer to the MSDS for more information.

3.Wipe the front and rear calibration guides again with an almost-dry Staticide wipe to remove any streaks.

IMPORTANT: When cleaning the front calibration area, be careful not to bend the white tabs; bending the tabs may cause paper feeding problems.

4. When finished, close the scanner cover.

78

A-61602 January 2008

Page 81
Image 81
Kodak A-61602 manual Cleaning the calibration area