Pixel Polish and Mac OS
With Macintosh operating systems, to use Pixel Polish when the utility is launched through Photoshop or Photoshop Elements, the largest unused block of memory in the system must be more than 128 MB.
With the Photoshop application open, check the amount of the largest unused block of memory before launching the utility. If the block of memory is less than 128 MB, use one of the following method to increase the volume:
-Close all other application running.
- Decrease the memory allocation to Photoshop; the memory allocated must not be reduced below 128 MB of RAM plus the requirements for
the application, see scanner system requirements on page 11.
-Increase the virtual memory. Add enough memory to the amount of the actual unused block of memory so that the total volume exceeds 128 MB.
Refer to Mac OS help to check the largest unused block of memory, to change the memory allo- cation of an application, and to set the virtual memory.
Checking Scanner Installation (Windows)
If the scanner was connected to the computer and turned on before the utility software was installed, the computer may not recognize the scanner unit even after the utility software is installed. Follow the instructions below to confirm the scanner driver is installed correctly.
1Windows 98, 2000, Me: right click on the
Windows XP: from the start menu go to the control panel. Click on the performance and main- tenance category. Click the system button to open the system properties window.
2Windows 2000 and XP: select the hardware tab in the properties window and click the device- manager button.
Windows 98 and Me: click the
3The driver file should be located in the
If “DS_Dual3” is not located in the imaging device location, open
87
