Chapter 3 Printer Driver
E
End Capture
When the virtual printer port is specified on the [End Capture] dialog shown by clicking [Details]
F
Finisher
When the Finisher is attached to the copier, you can select the Finisher setting from [None], [2 Trays], [3 Trays] or [4 Trays].
Default of the Finisher is [None].
When [None] is selected in the Finisher settings, or when the Finisher is not installed, the function has limits as follows;
•You can not select other settings than [Printer's Default] as an output tray.
•Staple settings can not be performed.
When [None] is selected in the Finisher settings, or when the Finisher is not installed, you can perform the Alternate printing.
In this case, it is required that the same size of paper for both portrait and landscape is set to the copier. (e.g.: A4/A4R, and B5/B5R)
Front Cover
By using [Paper]
Select either [On] or [Off].
Default of Front Cover is [Off].
When [On] is selected, select either [Blank] or [Printed].
When [Blank] is selected, nothing is printed on the first page.
When [Printed] is selected, the first page is printed on the front cover.
The tray for front covers is selected by using [Front/Back
Front Cover can not be set in the following conditions:
•When [B6R] is selected as a paper size,
•When Alternate is set to[On],
•When Duplex is set to [Booklet], or
•When sorting is set to [Group].
When Front Cover is set to [On], you can not use the Alternate printing and Sort.
