Konica Minolta IP-011 Paper type, Port settings, Print page borders, Print quality, Print Test

Chapter 3 Printer Driver

Paper type

[Plain], [OHT Film], [OHT Interleave] or [OHT Interleave Printed] can be selected from the list shown by clicking the [▼] button beside [Paper] tab- [Paper Type] box.

When Front/Back Cover is set, you can select only Plain.

When [Tray 1], [Tray 2], [Tray 3] or [Tray 4] is selected by using [setup] tab-[Paper]-[Paper Tray], OHT Film is not shown on the list.

When Paper Tray is set to [Bypass] and when [Sorting] is set to[Group], OHT Interleave and OHT Interleave Printed are not shown on the list.

When the Duplex printing is set to other settings than 1-Sided,and when Staple is set to other settings than Off, OHT Film, OHT Interleave and OHT Interleave Printed are not shown on the list.

Port settings

Click [Detail] tab-[Port settings] button to perform settings of the port selected on the [Print to the following port] box.

When the “LPT” is selected, the [Configure LPT

Port] dialog is shown by clicking the [Port

settings] button. The following settings are performed on the [Configure LPT Port] dialog.

When [Spool MS-DOS Print Job] is selected, a MS-DOS print job is spooled.

When [Check port state before printing] is selected, the port status is checked before printing.

Print page borders

Refer to Layout.

Print quality

Refer to Smoothing and Page Protection.

Print Test Page

Click [General] tab-[Print Test Page] button to perform a test print.

Printing to the following port

Select the port name of the IP-011 from the list shown by clicking the [▼] button beside [Details] tab-[Printing to the following port] box to change the printing port. Select a printing port from [COM1], [COM2], [FILE], [LPT1] and so on.

3-16 IP-011 Printer Controller