Kyocera FS-1920 manual Maintenance Messages, Message Corrective Action

Indicators and Messages

Maintenance Messages

The following table lists maintenance messages that you can deal with by yourself. If Call service person appears, turn off the printer, disconnect the power cord, and contact your Kyocera Mita dealer.

Message	Corrective Action
Add paper (paper source)	The paper has run out. Supply paper according to the paper source displayed (paper
	cassette, MP tray, or option paper feeder).
	Messages indicating the printer status (Ready, Please wait, Processing†,
	Waiting, and FormFeed Time Out†) are displayed alternately.
Call service	The ATTENTION indicator turns on and the READY indicator goes off. Indicates a
F000	problem with the controller and the operator panel. Call a service person. The printer
	does not operate when this message is displayed.
Call service	The ATTENTION indicator turns on. Indicates a controller error. Call a service person.
####	The printer does not operate when this message is displayed.
Call service	The ATTENTION indicator turns on. Indicates a mechanical error. Or an unsupported
####:0123456	option hardware has been installed. Be sure to install proper option hardware
	compatible with the FS-1920. Call a service person. 0123456 indicates the number of
	printed pages.
Cassette #	The paper cassette may not be propery inserted into the printer. Reinsert the paper
not loaded	cassette. The paper source number (#) is only displayed when there is an option paper
	feeder installed.
Check waste	The waste toner box is not installed. After installing the waste toner box, you should
toner box	be able to print. Replace the old waste toner box with the new one which is included
	in the toner kit. The message will also be shown if the waste toner box has become full.
;	The waste toner box should be replaced when the message display eventually shows
	Toner low. See Toner Container Replacement on page 3-2.
Clean printer	Please clean the inside of the printer. See Cleaning on page 3-9.
Press GO	This message will be displayed when replacing the toner container after the message
	Replace toner TK-50is displayed. After cleaning the inside of the printer, press
	the GO key and the printer will be ready for printing.
;	If Auto Continue is set to On, printing will be automatically resumed after a preset
	period of time.
Close duplexer	Open the option duplexer rear cover, then close tightly.
rear cover
Close	Open the left cover, then close tightly.
left cover
Close sorter	Open the sorter rear cover, then close tightly.
rear cover
Close	Open the stacker cover, then close tightly.
stacker cover
Close	Open the top cover, then close tightly.
top cover
Close paper	Open the paper transfer unit, then close tightly.
transfer unit
Duplex disabled	You attempted to print with a paper size and paper type that cannot be used for
Press GO	duplex printing. Press the GO key to print onto one-side of the paper only.

;:Alarm buzzer sounds when an error occurs. Press the CANCEL key to stop the alarm buzzer.

Table 4-4

4-7