Interface

6

Press the > key. Each time the or key is pressed, the display

changes as shown below.

>NetWare

>

On

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

>TCP/IP

>

On

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Range

Set this item to On when you connect to a network using NetWare. In submenu (>), frame mode can be selected from Auto, Ethernet, 802.2, 802.3, and 802.3 SNAP.

Set this item to On when you connect to a network using TCP/IP. Submenu (>) has items including DHCP, IP address, subnet mask address, and gateway address.

>EtherTalk Off

>Opt. StatusPage On

EtherTalk must be activated (On) for networking with Macintosh computers.

When the item is set to On, the printer prints out a network status page when it prints the printer status. See page 1-19

7

The following example explains how to activate TCP/IP protocol to

connect the printer in the network. You can select Netware or

 

EtherTalk in a similar manner.

 

 

 

 

 

 

 

>TCP/IP

>

 

 

 

On

 

 

 

If TCP/IP is currently Off is displayed, select On using the or

 

key. Press the ENTER key again.

>TCP/IP ? On

>TCP/IP > On

1-79

Page 95
Image 95
Kyocera FS-1920 manual NetWare, EtherTalk Off Opt. StatusPage On, TCP/IP ? On TCP/IP On