Kyocera FS-1920 manual Network Card Interface Status

Printing Test Pages

Network Card Interface Status Page

Option

Note

To use this function, the network interface card must be installed on the printer.

You can print out a status page for the network interface. The network interface card status page shows the firmware version, the network addresses, and other information under various network protocols about the network interface card. The default setting is On (print). If the setting is changed to Off (not print) as follows, however, the network interface status page will be printed when the printer status page is printed.

Printing out a network interface card status page may not be possible with some network interface cards. For details, see the manual for the network interface card.

1	Press the MENU key.
2	Press the or		key repeatedly until Interface > appears.
		Interface	>
		Parallel
3	Press the ENTER key. A blinking question mark (?) appears.

Interface

?Parallel

If you want to abandon the interface selection procedure, press the CANCEL key. The interface remains unchanged.

4	Press the or			key repeatedly until Option appears.
		Interface
		? Option
5	Press the ENTER key again. A > appears.
		Interface		>
			Option
6	Press the > key and then press the or					key repeatedly until the
	message display indicates					.
					>Opt. StatusPage

>Opt. StatusPage

On

1-19