Kyocera KM-1820 manual Printer Settings, Parallel Setting, Description

3 Printer Settings

Parallel Setting

System Menu/

Counter

Sor T

System Setting

Enter

Sor T

Parallel Setting

Enter

This chapter explains the procedures required to use the printer functions of the machine.

The settings needed to use the machine as a network printer can be made from the operation panel or using COMMAND CENTER. The procedures in this chapter only explain how to make the settings from the operation panel. To make settings using COMMAND CENTER, refer to Using COMMAND CENTER on page 8-1.

The parallel interface supports a bi-directional/high-speed mode according to IEEE standards. Use a parallel printer cable that complies with the IEEE1284 standard. Four modes are available.

Item	Description
Auto (default)	The machine automatically changes its communication
	mode to that of the host computer. Ordinarily, you should
	leave this setting unchanged.
Normal	The machine uses the standard communication method
	prescribed for Centronics interfaces.
High speed	This mode enables faster data transmission between the
	machine and the host computer. (Select this mode if
	printing problems occur when the machine is connected
	to a workstation.)
Nibble(high)	High speed data communication is used in compliance
	with the IEEE 1284 standard.

1 Access Parallel Setting.

If you are unsure how to use this route map refer to Accessing Menu Items on page vii.

2 Press S or T to select the parallel interface mode setting and press Enter. The display shows Completed and returns to the System Setting screen.

ADVANCED OPERATION GUIDE 3-1