Configuration Via Serial Mode or Telnet Port
|
| Message |
| Meaning |
|
|
|
|
|
|
| CONNECT |
| A network connection has been established. |
|
|
|
|
|
|
| NO CARRIER |
| A network connection has been closed. |
|
|
|
|
|
|
| RING n.n.n.n. |
| A remote device, having IP address n.n.n.n, is connecting to this |
|
|
| device. | |
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
0
1
2
3
4
OK
Connected
Ring
No Carrier
Error
Received commands must begin with the
The unit ignores any character sequence received not starting with AT, and only recognizes and processes single
If the Full Verbose option is in effect, the unit responds to an unrecognized command string that is otherwise formatted correctly (begins with AT and ends with carriage return) with the OK message and takes no further action.
If the
When an active connection is in effect, the unit transfers data and does not process commands received from the serial interface.
When a connection is terminated or lost, the unit reverts to command mode.
When an active connection is in effect, the unit terminates the connection if it receives the following sequence from the attached serial device:
No serial data is received for one second.
The character sequence +++ is received, with no more than one second between each two characters.
No serial data is received for one second after the last + character. At this time, the unit responds affirmatively per the selected echo/response mode.
The character string ATH is received, terminated with a carriage return. The unit responds affirmatively according to the selected echo/response mode and drops the network connection. The serial interface reverts to accepting command strings.
If this sequence is not followed, the unit remains in data transfer mode.
Modem Mode Command
ATDTx.x.x.x,pppp or ATDTx.x.x.x/pppp
Table 5-9. Modem Mode Commands
Function
Makes a connection to an IP address (x.x.x.x) and a remote port number (pppp).
WiPort™ User Guide |
