Uplink Failure Detection statistics
This menu option allows you to display Uplink Failure Detection (UFD) statistics. To reset UFD statistics, follow the command /cfg/ufd with the following argument: clear.
Command: /stats/ufd
Uplink Failure Detection statistics:
Number of times LtM link failure: 1
Number of times LtM link in Blocking State: 0
Number of times LtD got auto disabled: 1
The following table describes the Uplink Failure Detection (UFD) statistics:
Table 76 Uplink Failure Detection statistics
Statistic | Description |
|
|
Number of times LtM link failure | The total numbers of times that link failures were detected on the |
| uplink ports in the Link to Monitor group. |
|
|
Number of times LtM link in Blocking | The total number of times that Spanning Tree Blocking state was |
State | detected on the uplink ports in the Link to Monitor group. |
|
|
Number of times LtD got auto | The total numbers of times that downlink ports in the Link to Disable |
disabled | group were automatically disabled because of a failure in the Link |
| to Monitor group. |
|
|
Statistics dump
Command: /stats/dump
Use the dump command to dump all switch statistics available from the Statistics Menu (40K or more, depending on your configuration). This data can be used to tune or debug switch performance.
If you want to capture dump data to a file, set your communication software on your workstation to capture session data prior to issuing the dump commands.
Statistics Menu 87
