![](/images/new-backgrounds/1220827/220827241x1.webp)
The following table describes the LACP Configuration Menu options.
Table 118 LACP Configuration Menu options
Command | Description |
|
|
sysprio | Defines the priority value (1 through 65535) for the switch. Lower |
| numbers provide higher priority. The default value is 32768. |
|
|
timeout shortlong | Defines the timeout period before invalidating LACP data from a remote |
| partner. Choose short (3 seconds) or long (90 seconds). The default |
| value is long. |
| Note: HP recommends that you use a timeout value of long, to reduce |
| LACPDU processing. If your switch’s CPU utilization rate remains at 100% |
| for periods of 90 seconds or more, consider using static trunks instead of |
| LACP. |
|
|
port <port number> | Displays the LACP Port menu. |
|
|
cur | Display current LACP configuration. |
|
|
LACP Port configuration
Command: /cfg/l2/lacp/port <port number>
[LACP Port 2 Menu]
mode | - Set LACP mode | |
prio | - Set | LACP port priority |
adminkey | - Set | LACP port admin key |
cur | - Display current LACP port configuration |
The following table describes the LACP Port Configuration Menu options.
Table 119 LACP Port Configuration Menu options
Command | Description | |
|
| |
mode offactivepassive | Set the LACP mode for this port, as follows: | |
| • | off |
|
| Turn LACP off for this port. You can use this port to manually configure a |
| • | static trunk. The default value is off. |
| active | |
| • | Turn LACP on and set this port to active. Active ports initiate LACPDUs. |
| passive | |
|
| Turn LACP on and set this port to passive. Passive ports do not initiate |
|
| LACPDUs, but respond to LACPDUs from active ports. |
|
| |
prio | Sets the priority value for the selected port. Lower numbers provide higher | |
| priority. Default is 128. | |
|
| |
adminkey | Set the admin key for this port. Only ports with the same admin key and oper | |
| key (operational state generated internally) can form a LACP trunk group. | |
|
| |
cur | Displays the current LACP configuration for this port. | |
|
|
|
VLAN configuration
Command: /cfg/l2/vlan
[VLAN 1 Menu] |
|
|
name | - Set VLAN name |
|
stg | - Assign VLAN to a Spanning Tree Group |
|
add | - Add port to VLAN |
|
rem | - Remove port from VLAN |
|
def | - Define VLAN as list of ports |
|
ena | - Enable VLAN |
|
dis | - Disable VLAN |
|
del | - Delete VLAN |
|
cur | - Display current VLAN configuration |
|
|
|
|
| Configuration Menu 121 |