Operations-level port 802.1x options
Command: /oper/port <port number>/8021x
[802.1x Operation Menu]
reset | - | Reinitialize 802.1x access control on this port |
reauth | - | Initiate reauthentication on this port now |
Table 183
Command
reset
reauth
Description
•force unauth - the port is placed in unauthorized state, and traffic is blocked.
•auto - the port is placed in unauthorized state, then authentication is initiated.
•force auth - the port is placed in authorized state, and authentication is not required.
Operations-level VRRP options
Command: /oper/vrrp
[VRRP Operations Menu]
back | - Set virtual router to backup |
NOTE: This menu is available only on the GbE2c Layer 2/3 Ethernet Blade Switch.
Table 184
Command | Description |
|
|
back | Forces the specified master virtual router on this switch into backup mode. This is generally |
| used for passing master control back to a preferred switch once the preferred switch has |
| been returned to service after a failure. When this command is executed, the current master |
| gives up control and initiates a new election by temporarily advertising its own priority |
| level as 0 (lowest). After the new election, the virtual router forced into backup mode by |
| this command will resume master control in the following cases: |
| • This switch owns the virtual router (the IP addresses of the virtual router and its IP |
| interface are the same) |
| • This switch’s virtual router has a higher priority and preemption is enabled. |
| • There are no other virtual routers available to take master control. |
|
|
Operations Menu 161
