HP xw460c Blade manual IP interface configuration, Addr IP address, Mask IP subnet mask

Table 121 L3 Configuration Menu options

Command	Description
*frwd	Displays the IP Forwarding Menu.
*nwf <1-256>	Displays the Network Filter Configuration Menu.
*rmap <1-32>	Displays the Route Map Menu.
*rip	Displays the Routing Interface Protocol Menu.
*ospf	Displays the OSPF Menu.
igmp	Displays the IGMP Menu.
dns	Displays the IP Domain Name System Menu.
*bootp	Displays the Bootstrap Protocol Menu.
*vrrp	Displays the Virtual Router Redundancy Configuration Menu.
cur	Displays the current IP configuration.

* indicates menus that are available only on the GbE2c Layer 2/3 Ethernet Blade Switch.

IP interface configuration

Command: /cfg/l3/if <1-256>

[IP Interface	1	Menu]
addr	- Set IP		address
mask	- Set subnet mask
vlan	- Set VLAN number
ena	- Enable		IP interface
dis	- Disable IP interface
del	- Delete		IP interface
cur	- Display current interface configuration

The switch can be configured with up to 256 IP interfaces. Each IP interface represents the switch on an IP subnet on your network. The IP Interface option is disabled by default.

The following table describes the IP Interface Configuration Menu options.

Table 122 IP Interface Configuration Menu options

Command	Description
addr <IP address>	Configures the IP address of the switch interface, using dotted decimal notation. For
	example, 192.2.14.101
mask <IP subnet mask>	Configures the IP subnet address mask for the interface using dotted decimal
	notation. For example, 255.255.255.0
vlan <1-4095>	Configures the VLAN number for this interface. Each interface can belong to one
	VLAN, though any VLAN can have multiple IP interfaces in it.
ena	Enables this IP interface.
dis	Disables this IP interface.
del	Removes this IP interface.
cur	Displays the current interface settings.

NOTE: If you enter an IP address for interface 1, you are prompted to change the BOOTP setting.

Configuration Menu 123