First-time configuration
Introduction
This chapter describes how to perform
1.Connect to the switch console. After connecting, the login prompt displays.
GbE2c Ethernet Blade Switch for HP
Copyright(C)2006
Password:
2.Enter admin as the default administrator password.
The system displays the Main Menu with administrator privileges.
[Main Menu] |
|
info | - Information Menu |
stats | - Statistics Menu |
cfg | - Configuration Menu |
oper | - Operations Command Menu |
boot | - Boot Options Menu |
maint | - Maintenance Menu |
diff | - Show pending config changes [global command] |
apply | - Apply pending config changes [global command] |
save | - Save updated config to FLASH [global command] |
revert | - Revert pending or applied changes [global command] |
exit | - Exit [global command, always available] |
>> Main# |
|
|
|
3. From the Main Menu, enter the following command to access the Configuration Menu:
Main# /cfg
The Configuration Menu is displayed.
[Configuration Menu]
sys | - |
port | - Port Menu |
l2 | - Layer 2 Menu |
l3 | - Layer 3 Menu |
qos | - QOS Menu |
acl | - Access Control List Menu |
rmon | - RMON Menu |
pmirr | - Port Mirroring Menu |
ufd | - Uplink Failure Detection Menu |
dump | - Dump current configuration to script file |
ptcfg | - Backup current configuration to FTP/TFTP server |
gtcfg | - Restore current configuration from FTP/TFTP server |
cur | - Display current configuration |
Configuring Simple Network Management Protocol support
NOTE: SNMP support is enabled by default.
1.Use the following command to enable SNMP:
>># /cfg/sys/access/snmp disableread onlyread/write
2.Set SNMP read or write community string. By default, they are public and private respectively:
>># /cfg/sys/ssnmp/rcommwcomm
3.When prompted, enter the proper community string.
4.Apply and save configuration if you are not configuring the switch with Telnet support. Otherwise apply and save after the performing the “Optional Setup for Telnet Support” steps.
