RIP Interface configuration
Command: /cfg/l3/rip/if
[RIP Interface 1 Menu]
version | - Set RIP version |
supply | - Enable/disable supplying route updates |
listen | - Enable/disable listening to route updates |
poison | - Enable/disable poisoned reverse |
split | - Enable/disable split horizon |
trigg | - Enable/disable triggered updates |
mcast | - Enable/disable multicast updates |
default | - Set default route action |
metric | - Set metric |
auth | - Set authentication type |
key | - Set authentication key |
enable | - Enable interface |
disable | - Disable interface |
current | - Display current RIP interface configuration |
NOTE: This menu is available only on the GbE2c Layer 2/3 Ethernet Blade Switch.
The RIP Menu is used for configuring Routing Information Protocol parameters. This option is turned off by default. NOTE: Do not configure RIP version 1 parameters if your routing equipment uses RIP version 2.
The following table describes the RIP Interface Configuration Menu options.
Table 132 RIP Interface Configuration Menu options
Command | Description |
|
|
version 12both | Configures the RIP version used by this interface. |
| The default value is version 2. |
|
|
supply disableenable | When enabled, the switch supplies routes to other routers. This command is |
| enabled by default. |
|
|
listen disableenable | When enabled, the switch learns routes from other routers. This command is |
| enabled by default. |
|
|
poison disableenable | When enabled, the switch uses split horizon with poisoned reverse. When |
| disabled, the switch uses only split horizon. The default value is disabled. |
|
|
split disableenable | Enables or disables split horizon. The default value is enabled. |
|
|
trigg disableenable | Enables or disables Triggered Updates. Triggered Updates are used to speed |
| convergence. When enabled, Triggered Updates force a router to send update |
| messages immediately, even if it is not yet time for the update message. The |
| default value is disabled. |
|
|
mcast disableenable | Enables or disables multicast updates of the routing table (using address |
| 224.0.0.9). The default value is enabled. |
|
|
default disableenable | When enabled, the switch accepts RIP default routes from other routers, but |
| gives them lower priority than configured default gateways. When disabled, |
| the switch rejects RIP default routes. The default value is disabled. |
|
|
metric | Configures the route metric, which indicates the relative distance to the |
| destination. The default value is 1. |
|
|
auth nonepassword | Configures the authentication type. The default is none. |
|
|
key | Configures the authentication key password. |
|
|
enable | Enables this RIP interface. |
|
|
disable | Disables this RIP interface. |
|
|
cur | Displays the current RIP configuration. |
|
|
Configuration Menu 129
