RIP user configuration
NOTE: RIP commands are available only on the GbE2c Layer 2/3 Ethernet Blade Switch.
Command: /info/l3/rip/dump
RIP USER CONFIGURATION : RIP on updat 30
RIP Interface 2 : 102.1.1.1, enabled
version 2, listen enabled, supply enabled, default none poison disabled, trigg enabled, mcast enabled, metric 1 auth none,key none
RIP Interface 3 : 103.1.1.1, enabled
version 2, listen enabled, supply enabled, default none poison disabled, trigg enabled, mcast enabled, metric 1
IP information
Command: /info/l3/ip
Interface information: |
|
| |
1: 47.80.23.243 | 255.255.254.0 | 47.80.23.255, | up |
Default gateway information: |
|
| |
1: 47.80.22.1, | up |
|
|
2: 47.80.225.2, | up |
|
|
Current BOOTP relay settings: OFF
0.0.0.0, 0.0.0.0
Current IP forwarding settings: OFF, dirbr disabled
Current network filter settings:
none
Current route map settings:
The following interface and default gateway information is displayed (some fields apply only to the GbE2c Layer 2/3 Ethernet Blade Switch):
•Interface number
•IP address
•IP mask
•IP broadcast address
•Operational status
•BootP relay settings
•IP forwarding settings
•Network filter settings
•Route map settings
IGMP multicast group information
Command: /info/l3/igmp
[IGMP Multicast | Group Menu] | |
mrouter | - | Show IGMP Snooping Multicast Router Port information |
find | - | Show a single group by IP group address |
vlan | - | Show groups on a single vlan |
port | - | Show groups on a single port |
trunk | - | Show groups on a single trunk |
dump | - | Show all groups |
|
|
|
The following table describes the commands used to display information about IGMP groups learned by the switch.
Table 35 IGMP Multicast Group menu options
Information Menu 51
