Temporarily disabling a port
To temporarily disable a port without changing its stored configuration attributes, enter the following command at any prompt:
Main# /oper/port <port number>/dis
Because this configuration sets a temporary state for the port, you do not need to use apply or save. The port state will revert to its original configuration when the switch is reset. See the “Menu information” section in the “Operations Menu” chapter for other
Port link configuration
Command: /cfg/port <port number>/gig
[Gigabit Link | Menu] |
speed | - Set link speed |
mode | - Set full or half duplex mode |
fctl | - Set flow control |
auto | - Set auto negotiation |
cur | - Display current gig link configuration |
|
|
Use these menu options to set port parameters for the port link.
Link menu options are described in the following table and display on the Gigabit port configuration menus for the switch. Using these configuration menus, you can set port parameters such as speed, duplex, flow control, and negotiation mode for the port link.
The following table describes the Gigabit Link Configuration Menu options.
Table 100 Gigabit Link Configuration Menu options
Command | Description | |
|
| |
speed 101001000any | Sets the link speed. Not all options are valid on all ports. The choices include: | |
| • | 10 Mb/s |
| • | 100 Mb/s |
| • | 1000 Mb/s |
| • “any,” for automatic detection (default) | |
| Note: Ports | |
|
| |
mode fullhalfany | Sets the operating mode. Not all options are valid on all ports. The choices | |
| include: | |
| • | |
| • | |
| • “Any,” for automatic detection (default) | |
| Note: Ports | |
|
| |
fctl rxtxbothnone | Sets the flow control. The choices include: | |
| • Receive (rx) flow control | |
| • Transmit (tx) flow control | |
| • Both receive and transmit flow control (default) | |
| • | No flow control |
|
| |
auto onoff | Enables or disables | |
|
| |
cur | Displays current port parameters. | |
|
|
|
Configuration Menu 108
