Operations Menu
Introduction
Menu information
Command: /oper
[Operations Menu]
port | - Operational Port Menu |
vrrp | - Operational Virtual Router Redundancy Menu |
passwd | - Change current user password |
clrlog | - Clear syslog messages |
ntpreq | - Send NTP request |
The following table describes the Operations Menu options.
Table 181 Operations Menu options
Command | Description |
|
|
port <port number> | Displays the Operational Port Menu. |
|
|
*vrrp | Displays the Operational Virtual Router Redundancy Menu. VRRP is available only on |
| the GbE2c Layer 2/3 Ethernet Blade Switch. |
|
|
passwd | Allows the user to change the password. You need to enter the current password in |
characters> | use for validation. |
|
|
clrlog | Clears all Syslog messages. |
|
|
ntpreq | Allows the user to send requests to the NTP server. |
|
|
Operations-level port options
Command: /oper/port <port number>
[Operations Port 1 Menu]
8021x | - 8021.x | Menu |
rmon | - Enable/Disable RMON for port | |
ena | - Enable | port |
dis | - Disable port | |
cur | - Current port state | |
Table 182
CommandDescription
8021x | Displays the 802.1x Port Menu. |
rmon disableenable Enables or disables Remote Monitoring for the port. RMON must be enabled for any RMON configurations to function.
ena | Temporarily enables the port. The port will be returned to its configured operation mode | |
| when the switch is reset. | |
|
|
|
NOTE: | This command does not enable a port that has been disabled by an ekeying mismatch error. | |
|
|
|
dis | Temporarily disables the port. The port will be returned to its configured operation mode | |
| when the switch is reset. | |
|
|
|
cur | Displays the current settings for the port. | |
|
|
|
| Operations Menu 160 | |
