![](/images/new-backgrounds/1220827/22082739x1.webp)
3.From the Configuration Menu, use the following command to select the System Menu:
>>Configuration# sys
The System Menu is displayed.
[System Menu] |
|
syslog | - Syslog Menu |
sshd | - SSH Server Menu |
radius | - RADIUS Authentication Menu |
tacacs+ | - TACACS+ Authentication Menu |
ntp | - NTP Server Menu |
ssnmp | - System SNMP Menu |
access | - System Access Menu |
date | - Set system date |
time | - Set system time |
timezone | - Set system timezone (daylight savings) |
idle | - Set timeout for idle CLI sessions |
notice | - Set login notice |
bannr | - Set login banner |
hprompt | - Enable/disable display hostname (sysName) in CLI prompt |
bootp | - Enable/disable use of BOOTP |
dhcp | - Enable/disable use of DHCP on Mgmt interface |
reminders - Enable/disable Reminders | |
cur | - Display current |
4.Enter the following command to set the administrator password:
System# access/user/admpw
5.Enter the current administrator password at the prompt:
Changing ADMINISTRATOR password; validation required...
Enter current administrator password:
NOTE: If you forget your administrator password, call your technical support representative for help using the password
6.Enter the new administrator password at the prompt:
Enter new administrator password:
7.Enter the new administrator password, again, at the prompt:
8.Apply and save the change by entering the following commands:
System# apply
System# save
Changing the default user password
The user login has limited control of the switch. Through a user account, you can view switch information and statistics, but you cannot make configuration changes.
The default password for the user account is user. This password cannot be changed from the user account. Only the administrator has the ability to change passwords, as shown in the following procedure.
1.Connect to the switch and log in using the admin password.
2.From the Main Menu, use the following command to access the Configuration Menu:
Main# cfg
3.From the Configuration Menu, use the following command to select the System Menu:
>>Configuration# sys
4.Enter the following command to set the user password: