Chapter 10 Routing
Chapter 10 | Routing |
10.1Configuring Routing Protocol
You can configure Compex WP11A+ to either Dynamic or Static Routing Protocol.
In dynamic routing, RIP1 and RIP2 will be chosen when there are multiple routes on your network. The broadband Internet Gateway will keep on updating its IP routing table with the latest routing information by automatically adjusting to any physical changes in the network connection.
The routing table contains the network path and status information, which is used for forwarding the information. The Routing Information Protocol (RIP) will receive the routing information from other routers on the network.
10.2Adding Static Routes
If you already have existing multiple routers in your network and have multiple kinds of networks in your LAN, you may need to set up a static route between them to avoid the hassle of reconfigurating to the network. In this way, you can also have better control over the routes of your Compex WP11A+. For such cases, you can add a Static Routing to the router.
1.Click on Routing. Click on the “Add” button to add the Static Route in the IP Routing Table configuration shown.
Figure 10.2a IP Routing Table
62
