Compex Technologies WP11A+ Configuration on Various WAN Type, Configuring Static IP Connection

Chapter 8 Configuration on Various WAN Type

Chapter 8 Configuration on Various WAN Type

This section explains how to configure the Compex WP11A+ as a Wireless Broadband Internet Gateway to distribute Broadband Internet Access to a wireless network.

Besides Dynamic IP connection, Compex WP11A+ also supports Static IP, PPP over Ethernet, Singapore ADSL (Ethernet 512K) and Australia BPA Cable.

If you have chosen self-installation when you register for your broadband service, you should first test the ADSL modem together with the logon account on your PC or notebook. Ensure that it can connect successfully before attempting to run it with Compex WP11A+.

For simplicity and illustration purposes, it is assumed that the following LAN environment uses the IP address 192.168.168.xxx and Compex WP11A+ is using the default settings.

However, if you have assigned a different IP address for Compex WP11A+, then use the new settings in the setup procedures.

8.1Configuring Static IP Connection

1.Go to WAN setting at Command Window, click on the “Change” button and check the radio button next to the Static IP Address.

2.Click on “Save” button to update the data.

Figure 8.1a Select WAN Type - Static IP Address

44