Compex Technologies WP11A+ manual Appendix III Configuration and Commands on Telnet Interface

Appendix III Configuration and Commands on Telnet Interface

5.Go to Recovery folder and activate wp11arcv.bat.

The system will go to DOS Prompt automatically. Press any key to restore the firmware. It will run the command from the batch file: TFTP -i 192.168.168.1 PUT Wp11a286.img as shown below.

Figure AIII-2 DOS Prompt Environment

When done, the system will prompt you a message “Transfer successful: 505807 bytes in 1 seconds, 505887 bytes/s”.

When the firmware image file is uploaded, it will copy it to the flashrom. During uploading the firmware image file to Compex WP11A+, the DIAG LED will light up.

NOTE

The firmware image file, which you upload from the CD-ROM may not be the latest version. To get the most updated version, please go to www.compex.com.sg to download the firmware. Do not power down the device as data is being transferred.

Please note that your firmware image file might be different. Please enter the name of that image file.

Please ensure that there is constant power supply to Compex WP11A+ while performing the recovery process.

89