Lantronix 900-332 manual Factory Defaults, Exit Configuration Mode, Gpio Pins, Control Protocol

Contents

Disable TFTP Firmware Upgrade _____________________________________________ 5-21

Disable Port 77FE (Hex) ____________________________________________________ 5-21

Disable Web Server _______________________________________________________ 5-22

Disable Web Setup ________________________________________________________ 5-22

Disable ECHO Ports _______________________________________________________ 5-22

Enable Enhanced Password_________________________________________________ 5-22

Disable Port 77F0 (Hex) ____________________________________________________ 5-22

Factory Defaults _____________________________________________________ 5-22

Channel 1 Configuration ____________________________________________________ 5-23

Channel 2 Configuration ____________________________________________________ 5-23

WLAN Settings ___________________________________________________________ 5-23

Expert Settings ___________________________________________________________ 5-24

Security Settings __________________________________________________________ 5-24

Email Settings ____________________________________________________________ 5-24

Exit Configuration Mode _______________________________________________ 5-24

6: Configurable Pins 6-1

GPIO Pins ___________________________________________________________ 6-1

Features: _________________________________________________________________ 6-1

Control Protocol_______________________________________________________ 6-1

Guidelines ________________________________________________________________ 6-1

Commands _______________________________________________________________ 6-2

Examples____________________________________________________________ 6-4

7: Monitor Mode 7-1

Entering Monitor Mode via the Serial Port ___________________________________ 7-1

Entering Monitor Mode via the Network Port _________________________________ 7-1

Monitor Mode Commands _______________________________________________ 7-2

8: Updating Firmware 8-1

Obtaining Firmware ____________________________________________________ 8-1

Reloading Firmware ___________________________________________________ 8-1

Using TFTP: Graphical User Interface __________________________________________ 8-1

Using TFTP: Command Line Interface __________________________________________ 8-2

Recovering the Firmware Using the Serial Port ___________________________________ 8-2

9: Troubleshooting 9-1

Problems and Error Messages ___________________________________________ 9-1

Technical Support _____________________________________________________ 9-4

WiPort™ User Guide v