Lantronix XN manual To Configure Network Link Settings, Wlan Link Status and Scan Commands

6: Network Settings

To Configure Network Link Settings

Using Web Manager

To modify Ethernet (eth0) Link information, click Network on the menu and select Network 1 -> Link.

To modify Wireless (wlan0) Link information, click Network on the menu and select Network 2 -> Link -> Configuration.

Using the CLI

	To enter the eth0 Link command level: enable -> config -> if 1 -> link
	To enter the wlan0 Link command level: enable -> config -> if 2 -> link or
	enable -> config -> if 2 -> link -> choice 1234

Using XML

Include in your file: <configgroup name="ethernet" instance="eth0">

Include in your file: <configgroup name="wlan" instance="wlan0">

WLAN Link Status and Scan Commands

These commands display information about the current state of the wireless network.

	Table 6-4 Network 2 Link Scan
WLAN Link Information	Description
Commands
Scan “<network SSID>”	Perform a scan for devices within range of the PremierWave XN. Including the
	optional network SSID limits the scan to devices configured with the specified
	network SSID. Omitting the network SSID performs a scan for all devices in
	range.
	Note: When omitting the network SSID it is still necessary to include the
	opening and closing quotation marks (scan “”). When the PremierWave is
	associated with an access point, scanning is only preformed on the band on
	which the unit is connected.
Refresh scan results	 Check this to auto update the list of networks every 15 seconds.
every 15 seconds	 Uncheck this to stop auto update.
(checkbox)

The results of the scan command are presented in the following format in the table below:

Table 6-5 Network 2 Link Scan Results on WebManager

WLAN Link Scan Results Field	Description
Network Name	The Service Set Identifier (network name) of the device.
BSSID	Basic Service Set Identifier.
Ch/Channel	The channel on which the device is operating.

PremierWave XN User Guide 36