16: VIP Settings

Virtual IP (VIP) Configuration

Configuring Connect Mode tunnels to use VIP is a simple matter of configuring a tunnel as is normally done, but also enabling VIP in the Tunnel Host settings, and using a VIP Name for the address.

VIP Accept Mode tunnels do not require special configuration. If VIP access is enabled (in VIP configuration), then VIP Accept Mode requests from a ManageLinx device will be accepted.

 

Table 16-1 VIP Configuration

 

 

VIP Settings

Description

State

Enable (or disable) the VIP State to allow Virtual IP addresses to be used in

 

Tunnel Connect Mode and to accept incoming Virtual IP connection requests to

 

any local listening port.

 

 

To Configure VIP Settings

Using Web Manager

To configure VIP settings, click VIP on the menu and select Configuration.

Using the CLI

To enter the VIP command level: enable -> config -> vip

Using XML

Include in your file: <configgroup name=”vip”>

Virtual IP (VIP) Status

The VIP Status shows the current state of the conduit. When configured correctly, a conduit with the AccessMyDevice Gateway will be maintained at all times.

To View VIP Status

Using Web Manager

Click VIP on the menu and select Status.

Using the CLI

To enter the VIP command level: enable -> config -> vip, show status

PremierWave XN User Guide

96

Page 96
Image 96
Lantronix XN manual Virtual IP VIP Configuration, Virtual IP VIP Status, To Configure VIP Settings, To View VIP Status