Lantronix XN manual To Configure Tunnel Accept Mode Settings, Connect Mode, Block Network

	7: Line and Tunnel Settings
Tunnel Accept Mode	Description
Settings (continued)
Block Network	Set whether Block Network is enabled for debugging purposes. Choices
	are:
	 Enabled = if Enabled, incoming characters from the network will not be
	forwarded to the Serial Line. Instead, they will be buffered and will
	eventually flow off the network side.
	 Disabled = this is the default setting; incoming characters from the
	network are sent on into the Serial Line. Any buffered characters are
	sent first.
Password	Enter a password. This password can be up to 31 characters in length and
	must contain only alphanumeric characters and punctuation. When set,
	clients must send the correct password string to the unit within 30 seconds
	from opening network connection in order to enable data transmission.
	The password sent to the unit must be terminated with one of the following:
	 0A (Line Feed)
	 00 (Null)
	 0D 0A (Carriage Return/Line Feed)
	 0D 00 (Carriage Return/Null)
	If, Prompt for Password is set to Enabled and a password is provided, the
	user will be prompted for the password upon connection.
Email on Connect	Select an email profile number to which an email notification will be sent
	upon the establishment of an accept mode tunnel.
Email on Disconnect	Select an email profile number to which an email notification will be sent
	upon the disconnection of an accept mode tunnel.

To Configure Tunnel Accept Mode Settings

Using Web Manager

To configure the Accept Mode for a specific tunnel, click Tunnel in the menu and select Tunnel 1 -> Accept Mode.

Using the CLI

To enter Tunnel 1 Accept Mode command level: enable -> tunnel 1 -> accept

Using XML

Include in your file: <configgroup name="tunnel accept" instance="1">

Connect Mode

In Connect Mode, the PremierWave XCPremierWave XNPremierWave ENEDS-MD4/8/16 continues to attempt an outgoing connection on the network, until established. If the connection attempt fails or the connection drops, then it retries after a timeout. The remote node on the network must listen for the Connect Mode’s connection.

For Connect Mode to function, it must be enabled, have a remote station (node) configured, and a remote port configured (TCP or UDP). When established, Connect Mode is always on. Enter the remote station as an IP address or DNS name. The PremierWave XCPremierWave XNPremierWave ENEDS-MD4/8/16 will not make a connection unless it can resolve the address.

PremierWave XN User Guide 52