|
| 7: Line and Tunnel Settings |
|
|
|
| Tunnel Connect Mode | Description |
| Settings (continued) |
|
| Email on Connect | Select an email profile number to which an email notification will be sent upon |
|
| the establishment of an accept mode tunnel. |
|
|
|
| Email on Disconnect | Select an email profile number to which an email notification will be sent upon |
|
| the disconnection of an accept mode tunnel. |
|
|
|
To Configure Tunnel Connect Mode Settings
Using Web Manager
To configure the Connect Mode for a specific tunnel, click Tunnel in the menu and select Tunnel 1
Using the CLI
To enter the Tunnel 1 Connect Mode command level: enable
Using XML
Include in your file: <configgroup name="tunnel connect" instance="1">
Disconnect Mode
Specifies the optional conditions for disconnecting any Accept Mode or Connect Mode connection that may be established. If any of these conditions are selected but do not occur and the network disconnects to the device, a Connect Mode connection will attempt to reconnect. However, if none of these conditions are selected, a closure from the network is taken as a disconnect.
| Table |
|
|
Tunnel Disconnect | Description |
Mode Settings |
|
Stop Character | Enter the Stop Character which when received on the Serial Line, disconnects the |
| tunnel. The Stop Character may be designated as a single printable character or |
| as a control character. Control characters may be input in any of the following |
| forms: <control>J or 0xA(hexadercimal) or \10 (decimal). Disable the Stop |
| Character by blanking the field to set it to <None>. |
|
|
Modem Control | Set whether Modem Control enables disconnect when the Modem Control pin is not |
| asserted on the Serial Line. Choices are: |
| Enabled |
| Disabled (default) |
|
|
Timeout | Enter the number of milliseconds a tunnel may be idle before disconnection. The |
| value of zero disables the idle timeout. |
|
|
Flush Serial Data | Set whether to flush the Serial Line when the Tunnel is disconnected. Choices are: |
| Enabled |
| Disabled (default) |
|
|
PremierWave XN User Guide | 54 |
