Lantronix XN manual To Configure Line Settings, Line Command Mode Settings

		7: Line and Tunnel Settings
Line Settings (continued)		Description
Xon Char		Set Xon Char to be used when Flow Control is set to Software. Prefix decimal
		with \ or prefix hexadecimal with 0x or prefix a single control character
		<control>.
Xoff Char		Set Xoff Char to be used when Flow Control is set to Software. Prefix decimal
		with \ or prefix hexadecimal with 0x or prefix a single control character
		<control>.
Gap Timer		Set the Gap Timer delay to Set the number of milliseconds to pass from the
		last character received before the driver forwards the received serial bytes.
		By default, the delay is four character periods at the current baud rate
		(minimum 1 msec).
Threshold		Set the number of threshold bytes which need to be received in order for the
		driver to forward received characters.
	Table 7-2 Line Command Mode Settings
Line Command	Description
Mode Settings
Mode	Set the Command Mode state of the Line. When in Command Mode, a CLI session
	operates exclusively on the Line. Choices are:
	 Always
	 User Serial String
	 Disabled
	Note: In order to enable Command Mode on the Line, Tunneling on the Line must
	be Disabled (both Connect and Accept modes). Also, custom baud rates are not
	supported in Command Mode.
Wait Time	Enter the amount of time to wait during boot time for the Serial String. This timer
	starts right after the Signon Message has been set on the Serial Line and applies
	only if mode is “Use Serial String”.
Serial String	Enter the Text or Binary string of bytes that must be read on the Serial Line during
	boot time in order to enable Command Mode. It may contain a time element to
	specify a required delay in milliseconds x, formed as {x}. Applies only if mode is
	“User Serial String”. It may contain a binary character(s) of the form [x]. For
	example, use decimal [12] or hex [0xc].
Echo Serial String	Select Enable or Disable for Echo Serial String. Applies only if mode is “User Serial
	String”. Select enable to echo received characters backed out on the line while
	looking for the serial string.
Signon Message	Enter the string of bytes to be sent to the Serial Line during boot time. It may contain
	a binary character(s) of the form [x]. For example, use decimal [12] or hex [0xc].

To Configure Line Settings

Note: The following section describes the steps to view and configure Line 1 settings; these steps apply to other line instances of the device.

Using Web Manager

To configure a specific line, click Line in the menu and select Line 1 -> Configuration (Table 7-1).

PremierWave XN User Guide 47