Establishing the User Password
Use the SET DEVICE PASSWORD USER command at the management prompt to establish a user password. Note that you must be logged in as the administrator to change the user password.
OEBM> set device password user | [ENTER] | ||
Enter current administrator password: | <current password> [ENTER] | ||
New password: | <new user password> | [ENTER] | |
Verify: | <new user password> | [ENTER] | |
User password changed.
Configuring Other Bridge Module Parameters
The Bridge Module is factory set to certain default values that you may need to change before using the Bridge Module, for example the Bridge Module management prompt. If you are logged in as the administrator, you can use the SET command to change or add the following Bridge Module information:
❑Bridge Module name (alias)
❑Management prompt
❑Contact name and location
❑Terminal timeout value
❑Concentrator Reboot Values
A full explanation of these values and how you set them is discussed in Chapter 4 under the applicable SET command.
3 - 14 ONline Ethernet Bridge Module Installation and Operation Guide
