Once you have configured your terminal to match the factory defaults of the Bridge Module, press [ENTER] and the following header and password prompt are displayed:
copyright 1992 Chipcom Corporation ONline Bridge Module (v2.x)
Press [ENTER] and the Password prompt is displayed.
Password: [ENTER]
Initially the default password is a null string. You must enter a password within 10 seconds of receiving the Password: prompt or the terminal will display “Password timed out”. If this happens, just press [ENTER] to receive the password prompt again. By pressing [ENTER] at the Password prompt, the following greeting and the management prompt is displayed.
Welcome to system administrator services on ONline.
OEBM>
You are now logged in as the administrator with full access to all commands.
Setting Bridge Module Terminal Options (Optional)
This section is optional and is only used if you need to connect another device to an Bridge Module that runs at a slower baud rate or different parity or data bits values than the factory settings. For example, if you plan on connecting a 4800 baud modem to an Bridge Module so that you can remotely manage the concentrator, you need to change the Bridge Module factory default baud rate from 9600 to 4800.
Enter the following command to change the baud rate to 4800:
OEBM> set terminal baud 4800 | [ENTER] |
Once you change the baud rate (or parity or data bits values), you lose your connection to the terminal immediately. Therefore, you must change the corresponding value on the terminal and then press the [ENTER] key to return to the OEBM> prompt and then SAVE the terminal settings.
Management Functions 3 - 11
