3Com 5102B-EE installation and operation guide Installed Bridge Module

c.If you do not have a terminal connected to either the Bridge Module or to a management module, slide the module out from the concentrator (using the module extractor) and manually set the dip switches on the board to bridge two channels. Refer to Table 2-2 and Figure 2-2 in this chapter for an explanation of the dip switch settings.

5.Verify that the bridge is working properly by viewing the TX and RX LEDs. If there is traffic on the subnetworks, the transmit and receive LEDs on the front panel will be blinking. If there appears to be a problem, refer to Chapter 5, Troubleshooting.

Figure 2-6 shows an installed Bridge Module.

Bridge Module

Figure 2-6. Installed Bridge Module

Installation 2 - 17