Examining Parameters
The SHOW command lists the current value of any parameter you specify. For example, the SHOW SPANTREE command displays the current spanning tree parameters, as shown below.
OEBM> show spantree [ENTER]
Spanning Tree Parameters: |
|
Mode | Enabled |
Bridge Priority | 0 |
Path Cost Port 1 | 10 |
Path Cost Port 2 | 10 |
Hello Time (sec) | 2 |
Forward Delay Time (sec) | 15 |
Listen Time (sec) | 20 |
Spantree Hello Address: |
The SHOW DEVICE command displays the current device parameters and values for the Bridge Module.
OEBM> show device [ENTER]
ONline Ethernet Bridge Module (OEBM); SNMP Management
Name: OEBM
Boot EPROM Version: | v1.3 | Serial Number: 330658 Restarts: 7 | ||
Flash EPROM Version: v2.0 | Service Date: | / / | ||
Location: |
|
|
|
|
3rd Floor Engineering |
|
|
| |
|
|
| Port 1 | Port 2 |
MAC Address: | ||||
IP address |
|
| 127.0.0.1 | 127.0.0.1 |
Subnet Mask |
| FF.FF.FF.00 | FF.FF.FF.00 |
Default Gateway 0.0.0.0 0.0.0.0
For assistance contact:
Network Administrator
Diagnostics: ENABLED
SQE Mode: NORMAL
Management Functions 3 - 5