*******************

******************************************************************

3Com CORPORATION

 

 

Firmware Distribution Kit

Copyright 199X 3Com Corporation

This Firmware Distribution Kit will install and configure ProComm, a terminal emulation program, on you computer’s hard disk or on a second floppy drive. The program will reside in the directory called PROCOMM. Make sure you have the PROCOMM Distribution Diskette and the 3Com Firmware Distribution Diskette ready at all times during the installation.

*******************************************************************

*******************

Figure 6-3. Post-ProComm Installation Screen

This last step of the installation loads the ProComm configuration file. The configuration file sets the parameters that are used by ProComm to communicate with the Bridge Module. The parameters are as follows:

Note: Baud

= 9600

Data Bits

= 8

Stop Bits

= 2

Parity

= None

COM Port

= (Port number selected in Step 7)

Connect the RS-232 Cable

This step connects your PC to the Bridge Module so you can download the software to the Flash EPROM. Follow the instructions below:

1.Connect the provided RS-232 cable to the Bridge Module RS-232 serial port connector on the front panel of the module.

Firmware Download Instructions 6 - 7

Page 199
Image 199
3Com 5102B-EE installation and operation guide Connect the RS-232 Cable, Post-ProComm Installation Screen