SET FILTER STATIC_ADDRESS_TABLE

Use the SET FILTER STATIC_ADDRESS_TABLE command to add node addresses to the static address table.

Format

SET FILTER STATIC_ADDRESS_TABLE {variable} {MAC address}

Parameters

{variable} = always_forward never_forward_to_port1 never_forward_to_port2

{MAC address} = XX-XX-XX-XX-XX-XX

Example

OEBM>set filter static_address_table never_forward_to_port1 [ENTER] Enter MAC Address: 03-00-06-07-17-01 [ENTER]

Address added to filter table.

Do SAVE FILTER and RESET DEVICE to use changes.

Description

The SET FILTER STATIC_ADDRESS_TABLE command enables you to add node addresses to the static address table.

Always_Forward Parameter

Specifying the Always_Forward parameter with a subsequent MAC address will result in all received frames with the specified MAC address as the destination address being bridged (to the other bridge port) by the Bridge Module.

Management Commands 4 - 61

Page 135
Image 135
3Com 5102B-EE installation and operation guide SET Filter Staticaddresstable, AlwaysForward Parameter