*******************************************************************

******************

3Com CORPORATION

******************

 

 

 

Firmware Distribution Kit

Copyright 199X 3Com Corporation

 

This Firmware Distribution Kit will install and configure ProComm, a terminal emulation program, on you computer’s hard disk or on a second floppy drive. The program will reside in the directory called PROCOMM. Make sure you have the PROCOMM Distribution Diskette and the 3Com Firmware Distribution Diskette ready at all times during the installation.

*******************************************************************

Insert the ProComm Distribution Diskette in Drive A

Press any key to continue...

Figure 6-2. ProComm Installation Screen

Note: If the message “ProComm directory already exists, overwrite files?” displays, you have the choice of overwriting the files or quitting the installation. If you enter Y to overwrite the files, the existing ProComm files are deleted and then the new files are copied to the selected drive.

10.Once ProComm is installed on the hard drive, you will be prompted to swap in the 3Com FDK diskette as shown in Figure 6-3. Make sure you place the correct diskette in the disk drive before pressing [ENTER].

6 - 6 ONline Ethernet Bridge Module Installation and Operation Guide

Page 198
Image 198
3Com 5102B-EE installation and operation guide ProComm Installation Screen