SET SPANTREE PATH_COST_PORT1

Use the SET SPANTREE PATH_COST_PORT1 command to change the path cost of port 1 on the local Bridge Module.

Format

SET SPANTREE PATH_COST_PORT1 {variable}

Parameters

{variable} = 1 - 65535 (default is 10)

Example

OEBM> set spantree path_cost_port1 17 [ENTER]

Spanning tree parameter changed

Description

The SET SPANTREE PATH_COST_PORT1 command enables you to change the path cost of port 1 on the local Bridge Module.

The Spanning Tree Protocol seeks to minimize the path cost between each bridge and the Root Bridge (called the root path cost). The “root path cost” represents the distance between this bridge and the Root Bridge, and should be a lower value as the distance is lessened.

Modifying the value for the port 1 path cost at the local bridge may cause bridges “beneath” the local bridge in the Spanning Tree to change their path to the Root Bridge depending on the benefit or drawback of going through the local bridge.

Changing values may also result in a port currently in Blocking state on the local bridge to transition into Forwarding state and vice versa if the cost associated with the once Blocking port is now lower.

Management Commands 4 - 73

Page 147
Image 147
3Com 5102B-EE installation and operation guide SET Spantree PATHCOSTPORT1