SET COMMUNITY

Use the SET COMMUNITY command to create an entry in the community table.

Format

SET COMMUNITY {community} {IP Address} {access}

Parameters

{community} = {community name} or all

{IP Address} = {IP Address} or all

{access} = trap, read_write, read_trap, read_only, or all

All three of the parameter variables are required in the SET COMMUNITY command line.

Example

The following example creates the community table entry called admin and specifies that the associated workstation (with IP address 2.13.34.24) has both read and write access to the Bridge Module variables (through SNMP) and will receive all traps from the Bridge Module.

OEBM> set community admin 2.13.34.24 all

[ENTER]

Community set

Example

The following example gives the workstation with IP address 12.45.65.34 the community name super and enables the person who uses the workstation read_write access to the Bridge Module variables (through SNMP).

OEBM> set community super 12.45.65.34 read_write [ENTER]

Community set

4 - 42 ONline Ethernet Bridge Module Installation and Operation Guide

Page 116
Image 116
3Com 5102B-EE installation and operation guide SET Community