
Summarized Bridge Installation Procedure
The following list summarizes the procedure for installing and operating the Bridge Module.
❑Plug the Bridge Module into the ONline System Concentrator with the loopback connector attached to the AUI port and verify internal diagnostics.
❑Once the Bridge Module passes diagnostics, pull it back out of the concentrator and set the dip switches to the two channels you want to bridge (or set these values through network management without removing the module).
❑Plug the module back in the concentrator and the Bridge Module performs
❑Connect an ANSI terminal to the
❑Monitor the extended LAN using the bridge management capabilities through your connected terminal or via a modem or other interface providing asynchronous serial communications.