❑Filter
❑Spantree
❑Terminal
When you make configuration changes using the SET command, these changes are effective immediately but are not saved permanently. You must issue the SAVE command to keep the new configuration values. Only saved values are in effect upon reset of the module or concentrator.
Note: If a power failure occurs within the concentrator, all unsaved parameter values are lost.
Getting Started
This section briefly describes the steps to follow once the Bridge Module has been installed in the ONline System Concentrator and a terminal has been attached to its
Table 3-2. Procedures for Getting Started
Procedure | Command | Priority |
|
|
|
1. Configure your | Refer to your terminal | Mandatory |
terminal to default | vendor's documentation |
|
Bridge Module |
|
|
communication |
|
|
settings |
|
|
|
|
|
2. Configure the Bridge |
|
|
Module |
|
|
|
|
|
❑ Set administrator | SET DEVICE PASSWORD | Mandatory |
password | ADMINISTRATOR |
|
|
|
|
Management Functions 3 - 7
