Never_Forward_To_Port1 Parameter

Specifying the Never_Forward_To_Port1 parameter with a subsequent MAC address will result in all frames received at port 2 of the Bridge Module with the specified MAC address as the destination address being discarded by the Bridge Module rather than being bridged to port 1.

Never_Forward_To_Port2 Parameter

Similarly, specifying the Never_Forward_To_Port2 parameter with a subsequent MAC address will result in all frames received at port 1 being discarded if the destination address matches the specified MAC address.

Once you have selected the parameter you want to use, enter a hexadecimal MAC address in the following format:

XX-XX-XX-XX-XX-XX

Note that these address changes do not take effect until the changes are saved and Bridge Module is reset. Therefore, it is recommended that you enter the SAVE FILTER and RESET DEVICE commands after modifying the static address table so that these changes take effect as soon as possible.

4 - 62 ONline Ethernet Bridge Module Installation and Operation Guide

Page 136
Image 136
3Com 5102B-EE installation and operation guide NeverForwardToPort1 Parameter, NeverForwardToPort2 Parameter